Subscribe to Jergens News

Carbide Rest Buttons

    THE CLOSEST TOLERANCES IN THE INDUSTRY! Jergens is proud of the close tolerances held on the "B" dimension of our rest buttons. When it becomes necessary through constant wear to replace rest buttons, they can be replaced with the assurance of being within .0005 (.013mm) of the original location. Where replacement is not going to be a problem, we recommend the use of the Unground Buttons, which have a +.010 (.25mm) grinding stock to be ground after the fixture is assembled.

  • Material: Ground, Low Carbon Steel Unground, 52100
  • Finish: Black Oxide
  • Heat Treat:
  • Ground, Case Hardened 75-77 R30N
  • Unground, 58-62 Rc
  • Available in FixturePro™ Design Software

Click the Part Number in below chart
for Price and Stock Check.

Inch Buttons

Part NumberTypeABCDE
Carbide3/4.43751 1/32.5005-.50101/2

Metric Buttons

Part NumbersTypeABCDE

Unless otherwise stated, English units are inches (in) and pounds (lbs) and Metric units are millimeters (mm) and kilograms (kg).