Subscribe to Jergens News

Stop Modules

  
Click the Part Number in below chart
for Price and Stock Check.
CAD CAD Download Link

Part NumberDescription
RMS-VS CAD
Has a vertical V-shape jaw to hold round-shaped workpieces of various sizes
RMP-1 CAD
 
RMS-T CAD
In this stop module the same additional pieces can be used as in D-series low-profile clamps
RMS-R CAD
This stop type has two round, serrated contact areas which hold both big and small workpieces firmly in the correct position. The accuracy from every serration to the jaw surface is ± 0.25 mm
RMS-S2 CAD
More narrow than RMS-S, about the size of a B-series clamp
RMS-S CAD
Most common stop, which has two smooth & nitride jaws. Optimal for the 2nd setup, when OK-VISE clamps are used w/full force. Friction level is adequate even for roughing & other types of machining where high forces occur. The accuracy from every serration to the jaw surface is ± 0.01 mm
RMS-MS CAD
Especially suitable for machining of complex workpieces, or when extreme accuracy is needed & product-specific jaws are used for machining. One jaw is of the "normal" length, and normally it is smooth. For machining purposes this model is slightly bigger in size.
RMS-M CAD
Especially suitable for machining of complex workpieces, or when extreme accuracy is needed & product-specific jaws are used for machining. Has 2 extended jaws that are machinable. All combinations can be machined b/c these models are made of relatively soft material.
RMS-HS CAD
This model has a horizontal V-shape jaw to hold small round-shaped workpieces or bars. RMS-H has 2 such jaws.
RMS-G CAD
A grip model w/2 HSS pins that penetrate into the workpiece, leaving tiny marks on it. The friction is much higher than that of using the standard serrated jaw, against soft steel the friction co-efficient factor is up to 0,8.
RMS-D CAD
Both jaws diamond coated (D). The accuracy from every serration to the jaw surface is ± 0.25 mm.