Subscribe to Jergens News

Stainless Steel Ball Lock® Shanks

Any Ball Lock application requires at least two sets of shanks, receiver bushings and liners. The liners are placed into the fixture plate to insure extremely accurate positioning. If more than two shanks are required (to provide additional hold down force), omit the liner bushing so that these additional holes will not interfere with your primary locating holes.

  • Material: 17-4 PH Stainless Steel
  • Heat Treat: Rc 40-45
  
Click the Part Number in below chart
for Price and Stock Check.
CAD CAD Download Link

Part NumberFixture Plate Thickness +/- 0.005Shank Diameter (mm) AHead of Shank Height BHead of Shank Diameter CLength Under Head DMaximum Hold-Down Force (lbs)Recommended Screw Torque (Ft/lb)Hex Wrench Size for Set ScrewShank Repair Kit Part Number
49601SS CAD
0.750200.381.751.53300031/8 
49602SS CAD
1.000200.381.751.78300031/8 
49605SS CAD
0.500130.250.871.0875013/32 
49606SS CAD
0.750130.250.871.3375013/33 
49607SS CAD
0.500160.321.501.15120021/8 
49608SS CAD
0.750160.321.501.40120021/8 
49611SS CAD
0.750250.382.001.70700075/32 
49612SS CAD
1.000250.382.001.95700075/33 
49621SS CAD
0.750300.502.251.8810000123/16 
49622SS CAD
1.000300.502.252.1310000123/17 
49631SS CAD
0.750350.502.251.9715500191/4 
49632SS CAD
1.000350.502.252.2215500191/4 
49633SS CAD
1.500350.502.252.7215500191/4 
49634SS CAD
2.000350.502.253.2215500191/4 
49641SS CAD
0.750500.753.002.4520000383/8 
49642SS CAD
1.000500.753.002.7020000383/8 
49643SS CAD
1.500500.753.003.2020000383/8 
49644SS CAD
2.000500.753.003.7020000383/8 


Unless otherwise stated, English units are inches (in) and pounds (lbs) and Metric units are millimeters (mm) and kilograms (kg).